Renishaw PH10 Installation Guide download pdf (Page 24)

Installation

3.2 Installation of PHC10-2 controller

Both versions of the PHC10-2 controller can be used in a 19” rack system or as a stand-alone unit.

WARNING: Ensure the controller is disconnected from the mains supply during installation.

WARNING: Take care not to exceed the operation ambient of 50 °C around the unit. Do not install

near sources of heat. Forced cooling may be required in ﬁnal installation.

The dimensions of the controller are as follows:

Width: 290 mm (11.42 in)

Height: 88 mm (3.46 in)

Depth: 220 mm (8.66 in)

Weight: 2.8 kg (98.7 oz)

NOTE: Use the mounting screws supplied with this equipment. DO NOT replace with longer screws as

damage could occur.

3.2.1 Stand-alone installation

Four self-adhesive rubber feet are supplied with the unit for stand-alone use.

3.2.2 Mounting alone in a 19” rack

Figure 12 shows the PHC10-2 ready for mounting to a 19” rack.

Figure 12 - Mounting PHC10-2 in a 19” rack

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 73 74

No comments

Renishaw PH10 Installation Guide Page 24